Skip to content

Product safety retrofit notice: MAK automated flanged valves 3″, 4″, 6″, 8″ and 12″/600#

A product-safety retrofit notice was issued by ADAMS Armaturen GmbH on 23 December 2016 and this has been recently highlighted by the International Association of Oil & Gas Producers (IOGP).

The following text is copied from the notification:

Our MAK automated flanged valves MAK 3″, 4″, 6″, 8″ and 12″/600# have shown that the Thrust Bearing of the shaft can be exposed to higher than anticipated wear while in operation. If the wearing becomes too high there is a chance that the shaft can be discharged from the valve.

This has the potential to cause personal injury or damage to the surrounding area.

The Thrust Bearing is marked as a wearing part in the part list.

We strongly advise that you immediately inspect the Thrust Bearing with a depressurized valve to check for exposed wear, and contact us immediately for further action!

To address the issue, we will provide you with a modified Thrust Bearing and clamping device that will extend the life of the Thrust Bearing and mitigate the risk of premature failure.

Please confirm that you have received this information and that the information has been forwarded to the relevant person in your plant.

Please use the following information to contact us: [email][email protected][/email]

Please note that ADAMS takes great pride in its Quality promise and that is why we are proactively informing you about these findings.

Safety Event

Published: 25 October 2017
Download: IMCA SF 27/17

IMCA Safety Flashes
Submit a Report

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of all. The effectiveness of the IMCA Safety Flash system depends on Members sharing information and so avoiding repeat incidents. Please consider adding [email protected] to your internal distribution list for safety alerts or manually submitting information on incidents you consider may be relevant. All information is anonymised or sanitised, as appropriate.

IMCA’s store terms and conditions (https://www.imca-int.com/legal-notices/terms/) apply to all downloads from IMCA’s website, including this document.

IMCA makes every effort to ensure the accuracy and reliability of the data contained in the documents it publishes, but IMCA shall not be liable for any guidance and/or recommendation and/or statement herein contained. The information contained in this document does not fulfil or replace any individual’s or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.