Electrical flash burns

  • Safety Flash
  • Published on 1 April 2000
  • Generated on 5 December 2024
  • IMCA SF 02/00
  • 2 minute read

We have recently learned of this incident which occurred on an offshore installation.

What happened?

An electrician suffered superficial flash burns to his face, neck, ears and hands while operating a Merlin Gerin DA-type circuit breaker which was one of three incoming feeds to the platform 440v switchboard. The breaker was in the service position and attempts were being made to close the breaker and energise the switchboard. Difficulties had been experienced in closing the circuit breaker due to a defective component in the closing control circuit. This led to the use of an unapproved procedure, which had not been risk assessed.

The injured party had been standing at the circuit breaker with the panel door open and was using a tool to simultaneously overcome the defect while operating the ‘close’ push button on the front of the circuit breaker. While carrying out this action, the tool came into contact with live power circuit conductors which initiated an arcing fault and exposed the injured party to the dissipation of a high energy source.

Recommendations

The company involved has recommended to its personnel that:

  1. Users review procedures to ensure that any undocumented operations that have become custom and practice are subjected to a risk assessment.
  2. Users should ensure that all equipment malfunctions that require override procedures to obtain functionality are subjected to risk assessment.
  3. All design safety features of equipment should be utilised.

Latest Safety Flashes:

LTI: Finger injury during emergency recovery of ROV

A worker suffered a serious finger injury when their finger was caught between a crane wire and the recovery hook on an ROV.

Read more
BSEE: recurring hand injuries from alternative cutting devices

The United States Bureau of Safety and Environmental Enforcement (BSEE) has published Safety Alert 487.

Read more
NTSB: Crane wire failure

The National Transportation Safety Board of the United States (NTSB) published "Safer Seas Digest 2023".

Read more
Hot work performed outside of Permit to Work (PTW) boundary limit

A near miss occurred when a third-party contractor working removed a trip hazard from the vessel main deck, using a cutting torch and grinding disc.

Read more
Vital safety information (height of vehicle) found incorrect

“Height of vehicle” information displayed on a truck, was found to be incorrect.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.