Life raft lashing parted in rough weather

  • Safety Flash
  • Published on 28 January 2022
  • Generated on 7 April 2026
  • IMCA SF 03/22
  • 2 minute read

Lashing on a life raft gave way due to wear on stitching on the strap eye.

What happened?

During rough weather on a vessel at sea, the lashing on a life raft gave way due to wear on stitching on the strap eye. The life raft fell into the water and became inflated.

The life raft was recovered; the sea anchor was damaged, other equipment  was found intact, but the shell of the raft was lost at sea.

Photo of Life raft
Life raft lashing parted

Life raft lashing parted

Suggested lashing arrangement using wire lash strap

Suggested lashing arrangement using wire lash strap

What went wrong?

  • Lashing straps literally affected by “wear and tear” during poor weather condition.
  • Inspection of the straps was not part of the vessel planned maintenance system.

Actions

  • A “Y strap” wire lashing may be used (see illustration), given the approval of the manufacturer.
  • Regular inspections and pre-checks before rough weather.
  • Specific inspection of life raft lashings to be added to vessel planned maintenance system (PMS).

IMCA notes that consideration should be given to the possibility of corrosion and degradation, leading to failure of parts due to:

  • Long-term exposure to the weather and to the sea air.
  • Repeated stresses induced by the movement of the vessel.
  • Accumulated damage or stress over very long periods between inspections – years.
  • Difficulty in access for inspection.

Latest Safety Flashes:

MAIB: Sinking of tug Biter with loss of two lives

MAIB has published Accident Investigation 17/2024 relating to the girting and capsize of tug Biter with the loss of two lives.

Read more
Dropped object – strop parted over sharp edge

A cylinder was lifted to a height of approximately 6 metres over deck of the vessel, the sharp steel edges of the cylinder cut through the firehose protection and caused the strop to part.

Read more
Person injured when pry bar slipped

A crew member who was applying downward pressure to their pry bar to lift a track, fell towards the deck when the pry bar slipped.

Read more
MSF: High potential near miss during FRC maintenance

The Marine Safety Forum has published Safety Alert 26-01 relating to an incident where there was an unplanned lowering of an FRC to the sea

Read more
BSEE: Crane incident leads to serious facial injuries

BSEE has published Safety Alert 512 relating to a crane incident during well abandonment which led to a worker being struck and suffering serious facial injuries.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.