Damage and engine room flooding following contact by tugboat
- Safety Flash
- Published on 17 March 2020
- Generated on 14 May 2026
- IMCA SF 10/20
- 3 minute read
What happened?
A vessel suffered damage to the hull and engine room flooding due to contact with a tugboat during berthing. One of two tugs lost manoeuvrability and bumped into the vessel hull resulting in damage to engine room hull at frame no.42-45 portside.
The hull was torn 2 metres horizontally and 6 metres vertically leading to engine room flooding. The flooding was not stabilised by the use of the fire and general service (GS) pump and additionally, no.1 ballast pump for emergency bilge suction was started and then the flooding was brought under control.
Following the incident, interim and then permanent repairs were made, after which the vessel sailed following classification society and port state control verification of the seaworthiness of the repair.
What went wrong?
Our Member noted:
- Weather conditions were reported as rough weather, strong wind (25 knots) with waves of 3-4 metres.
- Vessel speed was 11.3 knots at the time of incident:
- There was no reduction of speed to allow the tug to make fast to the vessel.
- Master and deck officers did not realise how fast the vessel was going whilst the tugs were making fast to the vessel.
- Master/responsible officer failed to provide required stability data as requested by the classification society emergency response services.
Immediate causes:
- Vessel master failed to warn the pilot or discuss with the pilot the need to reduce speed for the tugboat to make fast the tug line to the vessel.
- Pilot then made the decision to make fast tug line with vessel maintaining high speed.
- Tug master failed to maintain safe distance from vessel for stable manoeuvrability.
- Rough weather, high seas and high wind.
Causal factors:
- Ineffective information exchange and communication
- Inadequate supervision:
- Misjudgement of vessel movement and external force (wind, wave and swells)
- Master and bridge team not aware/alert of communication between the pilot and tugs
- Competence factors: lack of experience of pilot and tug master for safe operation of tug line handling in consideration of rough weather and strong wind.
Root causes:
- Complacency – ‘task seen as routine’
- Procedures were not followed.
Actions
- Master to execute his overriding authority effectively and in timely manner.
- The bridge team should understand the pilot is on-board in an advisory capacity only and not in command of the vessel.
- Master/responsible officer to understand and be familiar with the vessel damage control plan and damage stability calculations.
Related Safety Flashes
-
IMCA SF 07/19
18 April 2019
-
-
IMCA SF 19/15
23 November 2015
-
IMCA SF 13/15
21 September 2015
IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.
The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.
All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.
IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.
The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.
Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.