Near-miss incidents during personnel transfer to offshore renewable energy installations
- Safety Flash
- Published on 16 April 2014
- Generated on 9 December 2025
- IMCA SF 06/14
- 3 minute read
A Member has reported a number of near miss incidents involving a workboat used to service wind turbine towers in the offshore wind farm sector. The near misses related to marine growth on the ladders and boat landing push tubes, which became exposed during a period of exceptionally low tides.
Incidents 1 and 2
In the first near miss incident, a technician slipped whilst on the rung of a ladder on the side of the turbine tower, but recovered – there was no injury or damage. The ladder was cleaned by scraping the rungs with a sharp tool.
In the second near miss incident, some days later, a technician reported that he had caught his knee on a protruding barnacle on the boat landing push tube. His immersion suit was not damaged and he was not injured.
Our member noted the following:
- The incidents occurred at a period of extremely low tides which exposed parts of the boat landing normally submerged.
- Not all small workboats are fitted with pressure washers so cleaning of boat landings might have to be performed manually.
- The manual method of cleaning by scraping the ladder rungs with a sharp tool was not effective.
- Although there was no injury or damage, the crew correctly reported the incidents and proposed revised methods of working.
The following actions were taken:
- A change to the method of cleaning -using a stiff brush and wiping with a rag: this was implemented the next day.
- Revision of risk assessment for personnel transfer to turbine towers.
- Amendment of company procedures to reflect new technique.
Incident 3
A technician transferring from a small workboat to an offshore wind turbine tower was snatched by his fall arrest device when the bow fender slipped on the boat landing.
Our member noted the following:
- The bow slippage was caused by an unanticipated wave trough.
- The wind farm operator had made a recent revision to the transfer method, to ensure that the transferring technicians were connected using fall arrest devices when on the deck of the vessel and not to disconnect until back on the deck.
- This revision did not include a step where slack in the tag line is handed to the attending deckhand to ensure that the line does not become caught if the bow slips.
- Concerns were raised about who should be watching for unexpected waves as it seems that everyone was concentrating on the transfer.
- A similar incident had been reported before but the revisions to procedures made at that time as a result were not wholly effective.
The following actions were taken:
Working in co-operation with the client, our member made a thorough revision of the procedures for personnel transfer in this context, particularly addressing the following:
- Slack in the fall arrest tag line should be handed to the deckhand.
- The Master is responsible for monitoring the passing wave sets and warning the crew of any changes.
Incidents 1 and 2 – Members may also refer to the following similar incidents (key word: ladder):
(Key issues in both – housekeeping and corrosion).
Members may also refer to the following similar incident (key words: turbine, slip):
Incident 3 – Members may also refer to the following similar incident:
IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.
The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.
All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.
IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.
The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.
Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.