Confined space entry fatalities

  • Safety Flash
  • Published on 28 August 2015
  • Generated on 14 December 2024
  • IMCA SF 12/15
  • 2 minute read

The Nautical Institute has published a safety bulletin regarding the death of five persons in a confined space entry incident.

The incident occurred when a pontoon was beached at an isolated location for repairs. At one point the person in charge of the pontoon entered a compartment approximately five metres deep; there were no checks on the air quality of that compartment before entry. Within a very short time after entering this tank he became unconscious and fell, face down, onto the plates below. One of the two co-workers that had remained outside attempted a rescue and was also rendered unconscious after entering the tank. A third worker then entered the tank and also succumbed.

Seeing the commotion and wanting to help, a man on the beach also entered the space to carry out a rescue and he too became unconscious. In short succession two others entered the tank but also succumbed. After more than an hour a successful rescue attempt was made and all bodies were removed. Resuscitation was attempted at length but of the six who entered the compartment, there was only one survivor.

This tragic incident serves a timely reminder on the dangers of uncontrolled entry into confined spaces.

Members should be aware that IMCA has published a safety promotional video – Working in confined spaces.

IMCA also has a safety pocket card – Confined spaces: The dangers

Latest Safety Flashes:

LTI: Finger injury during emergency recovery of ROV

A worker suffered a serious finger injury when their finger was caught between a crane wire and the recovery hook on an ROV.

Read more
BSEE: recurring hand injuries from alternative cutting devices

The United States Bureau of Safety and Environmental Enforcement (BSEE) has published Safety Alert 487.

Read more
NTSB: Crane wire failure

The National Transportation Safety Board of the United States (NTSB) published "Safer Seas Digest 2023".

Read more
Hot work performed outside of Permit to Work (PTW) boundary limit

A near miss occurred when a third-party contractor working removed a trip hazard from the vessel main deck, using a cutting torch and grinding disc.

Read more
Vital safety information (height of vehicle) found incorrect

“Height of vehicle” information displayed on a truck, was found to be incorrect.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.