Potential dropped objects in frame pockets

  • Safety Flash
  • Published on 10 September 2018
  • Generated on 13 December 2024
  • IMCA SF 20/18
  • 2 minute read

The Marine Safety Forum (MSF) has published Safety Alert 18-20 on Potential Dropped Objects in Frame Pockets. 

What happened?

When preparing a heavy lift to be discharged from an offshore supply vessel to an offshore installation, the vessel’s AB’s were carrying out final checks, which included checks for any potential dropped objects. During these checks, they discovered some debris within the frame pocket. The items were estimated to weigh approximately 1kg.

What went wrong? What were the causes?

Cargo checks onshore failed to spot the items before the lift had been loaded onto the PSV. This was apparently due to the lift frame positioning on the trailer which may have hampered the checks at the gantry.

Debris discovered within frame pocket

What actions were taken? What lessons were learned?

  • The potential dropped objects were removed from the pocket and the lift was safely and successfully discharged to the offshore installation.
  • This alert highlights the importance of final checks on all lifts prior to discharge offshore even though there had been previous checks onshore.

The full MSF safety alert can be found here.

The MSF notes that further information and guidance on the checking of cargo items for potential dropped objects can be found in ‘Best Practice for the Safe Packing & Handling of Cargo to & from Offshore Locations’ available at www.onshoreoffshorecargo.com.

Dropped objects or potential dropped objects from cargo are a frequent cause of incidents. Users of IMCA Safety Flashes can search the IMCA Safety Flash database themselves using any search word. Please browse to https://www.imca-int.com/alerts/safety-flash/ and enter text in the search box.

 

IMCA Safety Flash database

Latest Safety Flashes:

LTI: Finger injury during emergency recovery of ROV

A worker suffered a serious finger injury when their finger was caught between a crane wire and the recovery hook on an ROV.

Read more
BSEE: recurring hand injuries from alternative cutting devices

The United States Bureau of Safety and Environmental Enforcement (BSEE) has published Safety Alert 487.

Read more
NTSB: Crane wire failure

The National Transportation Safety Board of the United States (NTSB) published "Safer Seas Digest 2023".

Read more
Hot work performed outside of Permit to Work (PTW) boundary limit

A near miss occurred when a third-party contractor working removed a trip hazard from the vessel main deck, using a cutting torch and grinding disc.

Read more
Vital safety information (height of vehicle) found incorrect

“Height of vehicle” information displayed on a truck, was found to be incorrect.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.