Failure of threads – Follow up to “Corrosion coupon plug ejected from pressurised pipeline”
- Safety Flash
- Published on 6 October 2016
- Generated on 22 August 2025
- IMCA SF 26/16
- 2 minute read
The IOGP published safety alert number 273 in May 2016, regarding an incident in which a corrosion coupon plug was ejected from a pressurised pipeline.
What went wrong?
- The threads of the access fitting were worn down to such an extent, that they were unable to restrain the plug upon minor disturbance (the – turn of the plug).
- The access fitting was installed during pipeline construction in 1987. It is estimated to have been subject to over 140 retrieval and installation cycles.
- Bottom-of-pipeline debris can cause galling of threads on stainless steel plugs, which in turn can damage the threads of carbon steel access fittings.
- The Original Equipment Manufacturer (OEM) supplied thread tapping assembly service tool had been used routinely for every plug coupon retrieval and installation cycle without the use of flushing oil to remove debris from the threads.
- In the presence of bottom-of-pipeline debris and thread damage, the repetitive removal of internal thread material can lead to ever smaller contact surfaces, increasing contact stress, increasing wear rates and/or galling.
- Smaller thread contact surfaces reduce the ability of the access fittings to restrain the plug.
- Absence of a tool to determine the internal thread condition under pressurised conditions meant that the internal thread condition was unknown.
The main lessons learnt were summarised thus:
- Threaded access fittings, which are subject to frequent use of a thread tapping assembly service tool (used to clean internal threads from debris and galling damage) can suffer from reducing thread contact surfaces. This mechanism was previously not identified.
- The internal thread condition was neither confirmed after each use of a thread tapping tool nor periodically verified because this was an unknown degradation mechanism.
The full report can be found on the IOGP’s website at safetyzone.iogp.org/SafetyAlerts/alerts/Detail.asp?alert_id=276
IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.
The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.
All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.
IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.
The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.
Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.