- Enter the IMCA Awards 2024: We\'re looking for outstanding Safety, Sustainability, and GHG projects.
- IP Code: Mandatory Code enters into force on 1 July. Make sure your company is up to speed with the changes.
- Early Bird tickets available for the IMCA Global Summit 2024. 3-4 December, Utrecht, Netherlands. Members can save £400.
- Discover how we are helping Members reduce emissions: Explore the ProjectGHG hub now.
- Now booking. Join the Lifting and Rigging community at our Technical Seminar in Amsterdam. Thursday 12 September 2024
- Now booking. Underwater Ship Husbandry Seminar. 10 October 2024, Singapore.
Finger injury: What happens when you DON’T use the right tool for the right job
What happened
A crewman attempted to remove the impeller from a fire pump using a hammer and punching rod. While he was hammering, a steel splinter of the punching rod (3-4 mm) chipped off and punctured his right hand.
The incident happened during corrective maintenance to a fire pump. The injured person was tasked by the Chief Engineer to disassemble the pump, as the Chief was busy with other work. The injured person observed that the impeller was stuck on its shaft due to misaligned splines between impeller and shaft. He started to attempt removal of the impeller by knocking out the shaft using a hammer and a steel punching rod. The punching rod splintered and the splinter went through the injured person’s glove and entered the soft tissues between thumb and index finger.
What went wrong/causes
- The tools selected for the job were inadequate;
- An adequate and correct gear puller specially designed for the task was not available on board;
- Inadequate hand protection equipment was used for the task; cotton gloves were used instead of mechanical impact protection gloves, which were available onboard.
Lessons learnt
- Ensure the right tools to do the job are available;
- Proper PPE, whilst a last line of defence, can minimise consequences or prevent injuries from happening.
Members may wish to refer to the following similar incidents:
- RWC – Caught between: Finger smashed by tooling [An immediate cause was inappropriate or incorrect tools used for the job]
- Lost time injury (LTI): Finger injury whilst working in engine room [An immediate cause was improper use of equipment]
Safety Event
Published: 7 November 2017
Download: IMCA SF 28/17
IMCA Safety Flashes
Submit a Report
IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of all. The effectiveness of the IMCA Safety Flash system depends on Members sharing information and so avoiding repeat incidents. Please consider adding [email protected] to your internal distribution list for safety alerts or manually submitting information on incidents you consider may be relevant. All information is anonymised or sanitised, as appropriate.
IMCA’s store terms and conditions (https://www.imca-int.com/legal-notices/terms/) apply to all downloads from IMCA’s website, including this document.
IMCA makes every effort to ensure the accuracy and reliability of the data contained in the documents it publishes, but IMCA shall not be liable for any guidance and/or recommendation and/or statement herein contained. The information contained in this document does not fulfil or replace any individual’s or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.