Skip to content

Fire caused by hot work

A member has reported an incident in which a small fire was caused by hot work taking place on the deck above. The incident occurred when a repair was being performed by a sub-contractor on a steel plate in the forecastle area. The job involved using an oxy-acetylene torch to remove an old corroded plate. During this activity, the oxy-acetylene cutting of the plate caused heat transfer from the forecastle deck area to the store-man’s office area (located directly below the place where the hot work was being carried out). As a result, glowing slag fell on the store-man’s chair, which caught fire. There was no-one in the storeman’s office at the time. The fire detection equipment in the office caused the alarm to go off. There were no injuries.

Fire-damaged chair after the event
Fire-damaged chair after the event

Our member’s investigation revealed the following:

  • Immediate causes:
    • Fire watch location was not well planned by supervision;
    • Melt slag felt on top of the store-man’s chair.
  • Root Causes:
    • Failure to control and conduct of safe work (permit to work planning failed);
    • Failed check of the workplace;
    • Inadequate risk assessment (warning about the smell of smoke in the store-man’s office was not investigated by the fire watcher).

Our member took the following preventative and corrective measures:

  • Held discussion with all parties involved to ensure all understand their responsibilities;
  • Ensured that any spaces identified as at risk of heat transfer from hot work are identified in the appropriate section of the job risk analysis beforehand;
  • Raised awareness of correct identification of adjoining compartments/spaces in regard to hot work and heat transfer through bulkheads, decks, etc.;
  • Double check (second pair of eyes) to identify any deck penetrations to improve spatial awareness;
  • Ensure fire detection system is fully functional during hot work.

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of all. The effectiveness of the IMCA Safety Flash system depends on Members sharing information and so avoiding repeat incidents. Please consider adding [email protected] to your internal distribution list for safety alerts or manually submitting information on incidents you consider may be relevant. All information is anonymised or sanitised, as appropriate.

IMCA’s store terms and conditions ( apply to all downloads from IMCA’s website, including this document.

IMCA makes every effort to ensure the accuracy and reliability of the data contained in the documents it publishes, but IMCA shall not be liable for any guidance and/or recommendation and/or statement herein contained. The information contained in this document does not fulfil or replace any individual’s or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.