Dangers of battery charging

  • Safety Flash
  • Published on 1 January 2002
  • Generated on 13 December 2024
  • IMCA SF 01/02
  • 3 minute read

A member has reported the following incident which occurred on one of its vessels during normal operations. 

What happened?

One cell of a battery used on the engine popped out, causing a small amount of acid to spill out. Nobody was in the vicinity when this incident occurred, nobody was injured and no other damage took place.

On investigation, it was noticed that the electrolyte level in the battery was much lower than the minimum level indicated on the body of the battery, leading to a higher concentration of acid inside the battery cell. Due to the automatic continuous charging of this battery, the acid was electrolysed, forming hydrogen gas, which tried to escape and popped the battery cap.

The member pointed out the following dangers:

  • Sulphuric acid is highly corrosive. It can cause severe injury to any person who is handling it unless adequate precautions are taken. Acid fumes, if inhaled, can cause severe health problems;
  • Hydrogen gas is highly flammable. When escaping out of the battery, if the gas had come into contact with a spark, it would have ignited and caused tremendous damage, particularly in a space with other flammables close by.

Our member took the following action:

The company involved has reminded its employees of its in-house guidelines on storing and charging batteries and has arranged for the following notice to be posted near battery usage/charging areas.

“Charging of batteries causes the emission of flammable hydrogen gas. Incorrect connecting and disconnecting of battery leads may cause sparking which could explosively ignite any accumulated hydrogen. Thus battery charging, connecting and disconnecting should be considered as hazardous and adequate protective measures taken.

All battery charging shall be performed in a dedicated area, and all sources of ignition (i.e. smoking, naked flames and the use of any electrical or hand tools which might cause sparking) shall be prohibited within a radius of 3m from the battery charging facility.

All battery chargers shall be fitted with a 3-core power cable, three prong plug, and be properly earthed with a property attached ground.

Adequate ventilation shall be provided to ensure the rapid dispersion of any flammable hydrogen gas.

Eye protection (impact resistant chemical goggles) shall be worn at all times in the battery charging facility.

The charger power supply shall be disconnected prior to connecting or disconnecting batteries.

All battery cell covers or plugs shall be removed during charging, and not replaced until all ‘bubbling’ has stopped.

Electrolyte level shall be checked and if required topped up both before and after charging batteries.

Separate racks or shelving shall be provided for charged batteries and batteries waiting recharging. These shelves shall be a minimum of 1 meter from the charging bench. All shelves shall be open wooden shelving or purpose manufactured plastic racks, to prevent the accumulation of hydrogen gas.

The following equipment shall be available in the charging/storage area:

  • Dry powder fire extinguisher
  • Water source for washing away spilled electrolyte
  • Neutraliser for spilled acid (i.e. baking soda)
  • Eyewash station
  • Drainage facilities.”

Latest Safety Flashes:

LTI: Finger injury during emergency recovery of ROV

A worker suffered a serious finger injury when their finger was caught between a crane wire and the recovery hook on an ROV.

Read more
BSEE: recurring hand injuries from alternative cutting devices

The United States Bureau of Safety and Environmental Enforcement (BSEE) has published Safety Alert 487.

Read more
NTSB: Crane wire failure

The National Transportation Safety Board of the United States (NTSB) published "Safer Seas Digest 2023".

Read more
Hot work performed outside of Permit to Work (PTW) boundary limit

A near miss occurred when a third-party contractor working removed a trip hazard from the vessel main deck, using a cutting torch and grinding disc.

Read more
Vital safety information (height of vehicle) found incorrect

“Height of vehicle” information displayed on a truck, was found to be incorrect.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.