Workshop finger injury

  • Safety Flash
  • Published on 1 March 2001
  • Generated on 14 December 2024
  • IMCA SF 03/01
  • 2 minute read

A member has reported the following incident. 

What happened?

A senior mechanical technician was involved in bleeding a hydraulic hose connected between an A-frame and a pump unit. The coupling was loosened such as to allow the air to be vented from it. When the hydraulic fluid started to be ejected from the coupling which he was holding, and although he knew that the fluid could also emerge under pressure from a bleed hole on the side of the fitting, he somehow allowed his finger to come into contact with the fluid under pressure. His finger was subsequently injured which required hospital treatment.

The investigation conducted by the company’s workshop HSE advisor identified the following causes:

  • The procedure and risk assessment for this task was generic and did not address the specific issue.
  • There were no controls in place in the workshop for this type of activity.

As a result the following actions have been taken by the company involved:

  • An instruction has been issued to workshop personnel to ensure that hoses being bled are not handled but are mechanically restrained.
  • Awareness sessions have been instigated to highlight the incident with the hydraulics personnel. 
  • Review of workshop risk assessments has been started to identify suitability and adequacy for the range of work being undertaken.
  • Senior Mech. Technician, Workshop Manager and Electrical Supervisor are tasked to identify and develop procedures to control this type of activity in the future.

This issue again shows how a momentary lapse in concentration can lead to injury but also highlighted the need for more rigorous controls on such activities.

Latest Safety Flashes:

LTI: Finger injury during emergency recovery of ROV

A worker suffered a serious finger injury when their finger was caught between a crane wire and the recovery hook on an ROV.

Read more
BSEE: recurring hand injuries from alternative cutting devices

The United States Bureau of Safety and Environmental Enforcement (BSEE) has published Safety Alert 487.

Read more
NTSB: Crane wire failure

The National Transportation Safety Board of the United States (NTSB) published "Safer Seas Digest 2023".

Read more
Hot work performed outside of Permit to Work (PTW) boundary limit

A near miss occurred when a third-party contractor working removed a trip hazard from the vessel main deck, using a cutting torch and grinding disc.

Read more
Vital safety information (height of vehicle) found incorrect

“Height of vehicle” information displayed on a truck, was found to be incorrect.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.