Fire caused at the stern of a dive support vessel by flaring gas from a rig

  • Safety Flash
  • Published on 1 March 2005
  • Generated on 4 December 2024
  • IMCA SF 03/05
  • 2 minute read

A Member has reported an incident where the stern of a diving support vessel suffered fire damage caused by flaring gas from a rig vent.

What happened?

The vessel was secured to the diving location via stern lines to a production structure, in order to locate and mark pipelines in the area. An open ended vent on that structure was located near the stern of the vessel and had not been identified as a potential hazard. This open-ended vent was, in fact, a component of a secondary flare system, designed to provide pressure relief to production operations by venting product in the event that the primary system failed.

With the vessel on location, the compressors on the platform shut down, the primary flare system failed and the secondary system began to vent product near to the stern of the vessel. The product ignited, causing fire damage to the vessel stern deck and equipment in the area. Personnel responded quickly to extinguish the fire on the vessel and move off location. No personal injury occurred.

Lessons learnt

The Member has highlighted the following lessons learnt from the incident:

  • Risk assessment procedures should identify all potential hazards associated with a project, including such flare systems.

  • The location, contents and function of all flare systems should be identified at the planning stage, as part of identifying the safe work area, then checked once on location.

  • The isolation of all flare systems and vents in the work area should be verified prior to setting up on location.

  • Planned work should be communicated with platform personnel via a safety meeting upon arrival at location.

Latest Safety Flashes:

LTI: Finger injury during emergency recovery of ROV

A worker suffered a serious finger injury when their finger was caught between a crane wire and the recovery hook on an ROV.

Read more
BSEE: recurring hand injuries from alternative cutting devices

The United States Bureau of Safety and Environmental Enforcement (BSEE) has published Safety Alert 487.

Read more
NTSB: Crane wire failure

The National Transportation Safety Board of the United States (NTSB) published "Safer Seas Digest 2023".

Read more
Hot work performed outside of Permit to Work (PTW) boundary limit

A near miss occurred when a third-party contractor working removed a trip hazard from the vessel main deck, using a cutting torch and grinding disc.

Read more
Vital safety information (height of vehicle) found incorrect

“Height of vehicle” information displayed on a truck, was found to be incorrect.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.