Warning signs not respected

  • Safety Flash
  • Published on 1 July 2002
  • Generated on 17 January 2026
  • IMCA SF 05/02
  • 2 minute read

A Member has reported that an electrician was on the deck of a semi-submersible crane vessel and was going to the lower part of the J-lay tower (clamp area) in order to install lighting necessary for the night time working activities.

What happened?

To gain access to the tower he used a scaffold which had been an alternative route to it and which was directly connecting the vessel bow to that level just above the clamp area.

However, due to operational requirements, the scaffold had been disconnected from the tower and pulled toward the deck of the vessel. To indicate the hazard a white rope had been put close to the entrance, as well as a red tag that forbade the use of the scaffold.

Since the scaffold was not secured, it overturned under the weight of the electrician causing him to fall 13.8 m down, hitting the handrail of the narrow walkway located between the vessel and the clamp area. The electrician suffered fractures of his right arm and right leg. In addition, some of the pieces of the collapsed scaffold caused minor injuries to a scaffolder who was working in the clamp area.

Cause of the accident:

Despite all tool box talks held on board and the safety signs installed on the scaffold, the injured person by-passed the prohibition signals placed on the scaffold, risking his own safety and the safety of other employees.

Company’s corrective action:

  • Tool box talks with all personnel about the safe use of the scaffolds and respect of the warning signs.
  • Ensure installation of more evident safety signs.
  • Dismantle scaffolds immediately as soon as they become unnecessary.

Latest Safety Flashes:

High potential dropped object - cradle falls from trailer

A large “cradle insert” weighing many tonnes fell off a trailer during a lifting operation.

Read more
LTI – back injury

A member of the crew of a crew transfer vessel (CTV) badly pulled their back whilst helping with mooring operations.

Read more
NTSB: Engine room fire – put things back properly after maintenance

The National Transportation Safety Board of the United States (NTSB) has published report MIR 25-29.

Read more
BSEE: arc flash incident – is the wire still live?

The United States Bureau of Safety and Environmental Protection (BSEE) has published Safety Alert 506 relating to an arc flash incident.

Read more
Spontaneous explosion of a plastic ruler

There was a spontaneous brittle failure of a 30cm clear plastic ruler stored in an office drawer on a DSV.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.