UK HSE: Liquid petroleum gas (LPG) leak

  • Safety Flash
  • Published on 28 February 2022
  • Generated on 21 February 2026
  • IMCA SF 05/22
  • 2 minute read

The UK Health and Safety Executive (HSE) reports that the operator of the UK’s largest oil refinery has been fined for health and safety breaches after a leak of liquid petroleum gas (LPG) was discovered by a worker cycling home at the end of their shift.

What happened?

There was an uncontrolled release of around 15 tonnes of LPG through a valve near to the main roadway used by LPG road tankers visiting a refinery in Fawley, Hants, UK.  The leak went undetected for around four hours before being discovered by an employee on his way home. It took a further hour to establish the source of the leak with on-site emergency personnel having to enter the area to reset the valve.

What went wrong?

An investigation by the Health and Safety Executive (HSE) found that the leak occurred because:

  • LPG was put through the pipe work at too a high a pressure for the valve;
  • There was no process in place to detect the discrepancy in the flow in the pipe;
  • The company had failed to take all measures necessary to prevent a major incident.

The inspector said “The measures required to prevent incidents should be proportionate to the risks. Where companies handle large quantities of substances that can cause major incidents, such as LPG, they are required to have layers of protection in place to prevent incidents.

In this incident a number of those layers either failed or were not in place resulting in a significant leak. Even though there was no fire or injury on this occasion, there was potential for a major incident. The prosecution has been brought to highlight the importance of maintaining the layers of protection and preventing this kind of major leak.”

Latest Safety Flashes:

Fall from height during mooring due to rope tension reaction

Rope became entangled with the propellor during mooring operations of a tanker causing the operator to lose balance and fall onto the lower platform.

Read more
Missing protection – progressive wear on hydraulic hoses causes damage

During an inspection, several hydraulic hoses and fuel hoses were found in direct contact with surrounding surfaces and sharp edges.

Read more
Small engine room fire – flammable object ignited

While ramping up the starboard main engine, a small flammable foreign object ignited.

Read more
Positive: damage to Fast Rescue Craft davit wire rope caught before failure

During routine checks, it was observed that the FRC davit wire rope had a visible fracture at the socket termination area.

Read more
BSEE: Miscommunication and trapped pressure causes injury during valve maintenance

BSEE has published Safety Alert 509 relating to a gas release incident on an offshore platform.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.