Crew Transfer Vessel (CTV) hit protruding scaffolding on a supply vessel

  • Safety Flash
  • Published on 27 February 2024
  • Generated on 12 December 2024
  • IMCA SF 05/24
  • 2 minute read

A Crew Transfer Vessel (CTV) came into contact with protruding scaffolding on an OSV.

What happened?

During transfer of crew to an Offshore Supply Vessel (OSV) at anchor, a Crew Transfer Vessel (CTV) came into contact with protruding scaffolding on the OSV, causing minor damage to a railing on the CTV. This was the fifth such transfer of personnel without incident; the Master was aware of the protruding scaffolding. The fifth time, during manoeuvring the CTV stern towards the OSV, the CTV contacted the OSV protruding scaffolding, causing minor damage. There were no injuries. The Master of the CTV under-estimated both how far the scaffolding protruded and how the OSV would swing round whilst at anchor.

Crew Transfer Vessel (CTV) hit protruding scaffolding on a supply vessel

Showing the moment of collision

What went wrong?

  • Task seen as routine: the CTV Master and crew had carried out multiple passenger transfers in similar conditions on several occasions. Crew members did not see this as an imminent hazard and no changes were made to their approach, no need was seen for additional safety measure at that point in time.
  • The existing risk assessment did not address the protruding scaffolding nor the risk of the OSV swinging round whilst at anchor. 

Lessons

  • Greater account should have been taken of the repair works requiring protruding scaffolding.  A more comprehensive risk assessment was required, covering protruding objects and covering the potential for continuous swing on an anchored vessel.

Latest Safety Flashes:

LTI: Finger injury during emergency recovery of ROV

A worker suffered a serious finger injury when their finger was caught between a crane wire and the recovery hook on an ROV.

Read more
BSEE: recurring hand injuries from alternative cutting devices

The United States Bureau of Safety and Environmental Enforcement (BSEE) has published Safety Alert 487.

Read more
NTSB: Crane wire failure

The National Transportation Safety Board of the United States (NTSB) published "Safer Seas Digest 2023".

Read more
Hot work performed outside of Permit to Work (PTW) boundary limit

A near miss occurred when a third-party contractor working removed a trip hazard from the vessel main deck, using a cutting torch and grinding disc.

Read more
Vital safety information (height of vehicle) found incorrect

“Height of vehicle” information displayed on a truck, was found to be incorrect.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.