Small boat cradle collapsed during poor weather conditions

  • Safety Flash
  • Published on 21 May 2013
  • Generated on 11 December 2024
  • IMCA SF 08/13
  • 2 minute read

A Member has reported an incident in which a zodiac inflatable boat was dropped onto deck.

What happened?

The incident occurred when a dive support vessel (DSV) was at anchor outside the offshore oilfield waiting on weather. The wind picked up suddenly to 35 knots and as a result the vessel began to roll violently. This caused severe shock-load on the four securing ropes for the cradle supporting the boat.

Two of the ropes (on the seaward side) snapped, whereas the deck side ropes were still secured. The vessel continued to roll violently and the small boat cradle slid from the stand and fell on the deck. The two deck side ropes which were still securing the small boat caused it to flip/turn over during the fall.

There were no injuries and no environmental damage. The small boat sustained some damage.

Zodiac inflatable boat after collapse of stand

Zodiac inflatable boat after collapse of stand

 

Lessons learnt

Our Member took the following steps to prevent recurrence:

  • The securing mechanism was reviewed and modified.

  • Cargo lashing belt was introduced as additional securing means.

  • Additional skirting was fabricated and installed on the platform towards the deck-side as well.

  • Our member noted that appropriate securing of equipment and cargo against vessel movements should not be neglected.
inflatable boat on stand after reconstruction

Inflatable boat on stand after reconstruction

 

Latest Safety Flashes:

LTI: Finger injury during emergency recovery of ROV

A worker suffered a serious finger injury when their finger was caught between a crane wire and the recovery hook on an ROV.

Read more
BSEE: recurring hand injuries from alternative cutting devices

The United States Bureau of Safety and Environmental Enforcement (BSEE) has published Safety Alert 487.

Read more
NTSB: Crane wire failure

The National Transportation Safety Board of the United States (NTSB) published "Safer Seas Digest 2023".

Read more
Hot work performed outside of Permit to Work (PTW) boundary limit

A near miss occurred when a third-party contractor working removed a trip hazard from the vessel main deck, using a cutting torch and grinding disc.

Read more
Vital safety information (height of vehicle) found incorrect

“Height of vehicle” information displayed on a truck, was found to be incorrect.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.