Skip to content

Arm injury whilst using pillar drill

What happened?
The Marine Safety Forum (MSF) reports another incident wherein a crew person was injured following misuse of a pillar drill. Crew were in the process of using a piece of 2mm metal plate to manufacture a metal blank for a pipe on the vessel’s hot water system. It was necessary to drill a small hole (6mm) at one end of the plate. For this operation, it was decided to use the workshop pillar drill. Whilst drilling the metal plate the drill bit became stuck. This then forced the metal plate out of the drill vice. When the operator reached up to stop the machine the metal plate that was stuck to the drill bit dislodged, flew off the drill bit and hit his left arm.

What went wrong? What were the causes?

The MSF alert identifies the following issues:

  • The task had not been properly risk assessed;
  • The wrong tool had been selected for the job;
  • The vice holding the job had not been sufficiently tightened;
  • The speed of the drill had not been adjusted for drilling metal;
  • The injured person was “not wearing his personal protective equipment (PPE) correctly”.

The MSF alert can be found here

It is conspicuous that this is the third incident reported during 2017 in which crew have injured themselves whilst using a pillar drill. Members may wish to reiterate to their crews the fundamentals of safety when working with rotating machines of all kinds.

Please refer to the following similar incidents:

Safety Event

Published: 21 December 2017
Download: IMCA SF 32/17

Relevant life-saving rules:
IMCA Safety Flashes
Submit a Report

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of all. The effectiveness of the IMCA Safety Flash system depends on Members sharing information and so avoiding repeat incidents. Please consider adding [email protected] to your internal distribution list for safety alerts or manually submitting information on incidents you consider may be relevant. All information is anonymised or sanitised, as appropriate.

IMCA’s store terms and conditions ( apply to all downloads from IMCA’s website, including this document.

IMCA makes every effort to ensure the accuracy and reliability of the data contained in the documents it publishes, but IMCA shall not be liable for any guidance and/or recommendation and/or statement herein contained. The information contained in this document does not fulfil or replace any individual’s or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.