Skip to content

Near miss: Lever Hoist Failure

What happened?

A lever hoist failed causing a load to descend to deck in an uncontrolled manner. The near miss incident occurred when a set of 1m trenching swords were being lowered to deck. The lever hoist being used was rated to 1.6Te, more than capable of lifting the load which was approximately 200kg in weight.

The rigging arrangement used was correct and all items of rigging had been recertified by a competent authority in recent months, including a limited load test.

What were the causes? What went wrong?

  • On investigation and inspection, worn cog teeth were found. A toothed part of the gear assembly (see figure 1) was found to have excessive wear;
  • This gear assembly was not visible without stripping the unit, so wear would not have been evident during pre-use checks. Strip down of a working unit would invalidate the manufacturer’s warranty and certification;
  • Our member noted that a thorough examination cannot be conducted in situ and units must be taken to a workshop for full examination.


Our member took the following actions:

  • Review and amend the process for recertification of rigging with moving / wearing parts;
  • Arrange for supply of newly certified rigging lofts on a 6-monthly basis;

Revised internal documentation on lifting operations appropriately.

Safety Event

Published: 4 September 2020
Download: IMCA SF 26/20

Relevant life-saving rules:
IMCA Safety Flashes
Submit a Report

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of all. The effectiveness of the IMCA Safety Flash system depends on Members sharing information and so avoiding repeat incidents. Please consider adding [email protected] to your internal distribution list for safety alerts or manually submitting information on incidents you consider may be relevant. All information is anonymised or sanitised, as appropriate.

IMCA’s store terms and conditions ( apply to all downloads from IMCA’s website, including this document.

IMCA makes every effort to ensure the accuracy and reliability of the data contained in the documents it publishes, but IMCA shall not be liable for any guidance and/or recommendation and/or statement herein contained. The information contained in this document does not fulfil or replace any individual’s or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.