Securing of loads

  • Safety Flash
  • Published on 1 February 2005
  • Generated on 27 February 2026
  • IMCA SF 02/05
  • 2 minute read

An incident has been reported to IMCA which, although relating to a road incident, provides an important reminder in relation to the securing of loads.

During transportation of five empty skips between a shore base and terminal, the top-most skip was blown from the top of the stack and landed on the road. No injuries occurred and no vehicles were damaged, but evasive action appears to have been taken by third party vehicles on the road to avoid the skip. There was the potential for multiple permanent injuries or fatalities and for damage to property.

The skip was lifted back onto the truck, secured to the other skips and to the truck with a strop and the journey was recommenced.

On arrival at the terminal the incident was reported to the site management and the local police. 

Imcasf02 05 Image5

What were the causes?

An investigation was then initiated, which identified the following likely causes:

  • The skips were stacked five high, one on top of the other, significantly above the height of the truck cabin.

  • There was high wind loading – the wind increased during the journey to approximately gale force, with gusting.

  • The skips had been inadequately secured to the truck, with no strops used.

It was noted by a Member that the skips were reloaded on one lorry and the journey was resumed in much the same manner, albeit with an extra strop attached.

Latest Safety Flashes:

Fall from height during mooring due to rope tension reaction

Rope became entangled with the propellor during mooring operations of a tanker causing the operator to lose balance and fall onto the lower platform.

Read more
Missing protection – progressive wear on hydraulic hoses causes damage

During an inspection, several hydraulic hoses and fuel hoses were found in direct contact with surrounding surfaces and sharp edges.

Read more
Small engine room fire – flammable object ignited

While ramping up the starboard main engine, a small flammable foreign object ignited.

Read more
Positive: damage to Fast Rescue Craft davit wire rope caught before failure

During routine checks, it was observed that the FRC davit wire rope had a visible fracture at the socket termination area.

Read more
BSEE: Miscommunication and trapped pressure causes injury during valve maintenance

BSEE has published Safety Alert 509 relating to a gas release incident on an offshore platform.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.