Fatality: fall from height

  • Safety Flash
  • Published on 10 November 2010
  • Generated on 13 February 2026
  • IMCA SF 07/10
  • 2 minute read

A Member has reported an incident in which a worker was killed, falling 19 metres from a column walkway.

What happened?

The person was a fitter putting in place a final piece of grating on an overhead walkway (see Figure 1 below). The worker was standing on a platform made from two planks. As the worker was moving the grating, one plank fell down causing the worker to swing, lose his balance and fall to his death.

Location from which worker fell

Location from which worker fell

Members are encouraged to remind their personnel of the following basic safety principles when working at height:

  • When working at height with fall exposure, 100% fall protection should be required.
  • Personnel working at height should be properly trained to use fall protection devices.
  • Personnel working at height should wear full body harnesses fitted with lanyards.
  • Fall arrest equipment should be carefully inspected before and after each use.
  • Temporary platforms should be properly secured.
  • Platforms and walkways shall be kept free from obstacles such as materials, equipment, tools and rubbish, etc., which might fall or obstruct safe working activities.

Members are reminded of IMCA’s safety promotional material on working at height, which includes safety pocket cards, posters and a DVD:

  • Working at height (video, pocket card, poster) – promotes the need for safety awareness, discusses various hazards and provides real-life demonstrations of good practice. Includes subtitles in key languages for use with a variety of offshore workforces
  • Avoiding dropped objects (pocket card, poster)

Latest Safety Flashes:

Fall from height during mooring due to rope tension reaction

Rope became entangled with the propellor during mooring operations of a tanker causing the operator to lose balance and fall onto the lower platform.

Read more
Missing protection – progressive wear on hydraulic hoses causes damage

During an inspection, several hydraulic hoses and fuel hoses were found in direct contact with surrounding surfaces and sharp edges.

Read more
Small engine room fire – flammable object ignited

While ramping up the starboard main engine, a small flammable foreign object ignited.

Read more
Positive: damage to Fast Rescue Craft davit wire rope caught before failure

During routine checks, it was observed that the FRC davit wire rope had a visible fracture at the socket termination area.

Read more
BSEE: Miscommunication and trapped pressure causes injury during valve maintenance

BSEE has published Safety Alert 509 relating to a gas release incident on an offshore platform.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.