Person slipped when exiting bathroom into cabin
- Safety Flash
- Published on 27 March 2023
- Generated on 4 December 2024
- IMCA SF 08/23
- 2 minute read
A crew member stepped out of the bathroom onto the cabin mat, when the mat slipped resulting in the crew member falling backwards, striking his lower back on the base of the bathroom door frame.
What happened?
A crew member stepped out of the bathroom onto the cabin mat, when the mat slipped resulting in the crew member falling backwards, striking his lower back on the base of the bathroom door frame.
The medic checked the injured person, identifying some swelling and a small abrasion. In follow up with the medic, the injured person reported feeling a little sore, but with no further symptoms, and returned to normal working duties.
Investigation identified that the cabin mat did not have any anti-slip material on the underside. A check was completed on all cabins which found a number of mats which had the potential to slip due to no anti-slip or rubber material underneath. The assumption had been made that every cabin had an anti-slip type mat.
Investigation identified that the cabin mat did not have any anti-slip material on the underside.
A check was completed on all cabins which found a number of mats which had the potential to slip due to no anti-slip or rubber material underneath. The assumption had been made that every cabin had an anti-slip type mat.
Our Member noted that this incident could have resulted in a far more serious injury.
What went right?
- The accident was promptly reported to the medic by the injured person.
- Most of the cabins were found to have the correct anti-slip type mats fitted.
What went wrong? What was the cause?
Cloth based mats were being used instead of rubberised (anti-slip) mats.
There were not sufficient rubberised mats to supply each cabin.
Cloth based cabin mats do not offer any anti-slip properties.
Lessons learned
- The immediate corrective action was to apply deck grip tape, until suitable anti-slip mats were available.
- An adequate stock of rubberised matting should be maintained onboard.
- If there’s a temporary need to use cloth based mats, some form of anti-slip material should be used to prevent the mats from slipping.
- Inspections of accommodation areas should highlight where anti-slip mats are not present or not available.
Related safety flashes
-
IMCA SF 16/20
22 May 2020
-
IMCA SF 13/18
22 June 2018
-
IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.
The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.
All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.
IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.
The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.
Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.