Structural failure of a transponder housing

  • Safety Flash
  • Published on 1 January 1999
  • Generated on 6 November 2026
  • IMCA SF 01/99
  • 1 minute read

Recently it was reported that the end of a transponder stored in an on-shore workshop blew off.

What happened?

The transponder had been in storage for a couple of months after being demobilised from the offshore site.

The cause was identified a result of seawater leaking into the housing during subsea operation – this reacted with the electrolyte in the battery pack and produced gas. Over a period the gas pressure built up causing the plastic retaining ring to fail which enabled the end to blow off. It was noticed that the vent bleed valve on the housing was closed.

The contractor involved has made a number of recommendations including:

  • Where practicable, a proper vent valve should be fitted to the highest point of the housing.
  • Caution should be taken when opening up housings.
  • Housings should be vented prior to shipping them back to storage or other worksites.

Latest Safety Flashes:

Cyber-attack on vessel

An oil tanker suffered a cybersecurity incident.

Read more
MAIB: Normalising of unsafe practice – fatal man overboard incident

MAIB have published Accident Investigation Report 16/2026 into a fatal man overboard incident on board a bulk carrier offshore Sweden.

Read more
Dust explosion in Bow thruster motor

Upon activation of the bow thruster, there was a loud explosion within the forward section of the workboat.

Read more
Dropped bulk bag during loading operations

A dropped object incident occurred during quayside lifting when a bulk bag failed due to incorrect loading.

Read more
Failure of sea-fastening on the leg of a jack-up barge

During a sea passage, prevailing sea conditions caused a jack-up barge to experience rolling and pitching motions.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.