LTI: cut to hand from protruding hose clip (Marine Safety Forum)

  • Safety Flash
  • Published on 22 June 2018
  • Generated on 13 November 2025
  • IMCA SF 13/18
  • 2 minute read

The Marine Safety Forum (MSF) has released the below safety alert 18-10.

What happened?

Not long after a vessel departed port, a crew member suffered a serious cut to his hand which led to an LTI. The incident occurred when he was carrying boxes through the galley and caught his hand on the sharp edge of a hose clip protruding in the transit area. First Aid was administered on-board; however, the Master deemed further medical attention was required and the vessel returned to port. The crew member was sent ashore to the local hospital where medication and seven stitches were applied. The crew member was subsequently declared unfit for work for seven days.

Crew member carrying boxes caught hand on protruding hose clip

What actions were taken?

The offending sharp edge was quickly covered to prevent further injury. The crew member had only been on-board for two days and it is likely that he was not fully appraised or aware of the hazards in his new work area.

The full alert can be found on the MSF website.

This incident is brought to the attention of IMCA members because this was an avoidable injury with costly consequences, in that the vessel had to return to port and the injured person was unfit for work for seven days.

Members may also wish to look at the following safety video:

Latest Safety Flashes:

Bunker hose obstructing emergency exit

A bunker hose was discovered routed in a way that partially obstructed the stern emergency exit hatch.

Read more
Watertight door and emergency hatch found open at sea

Watertight doors and an emergency hatch were observed open in the ER (Engine Room) during an offshore audit.

Read more
ATSB: Undocumented modification contributed to steam burns

An unplanned pressure release resulted in burn injuries to three crew members.

Read more
Smoke in the battery room

Smoke was observed in the battery room of a vessel alongside.

Read more
Hull crack arising from vibration

A small vessel built of aluminium experienced vibration coming from the propeller.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.