Platform supply vessel involved in a near-miss whilst on location

  • Safety Flash
  • Published on 30 June 2016
  • Generated on 2 October 2026
  • IMCA SF 17/16
  • 2 minute read

The Marine Safety Forum has published the following safety alert regarding a near miss in the 500m zone.

What happened?

A PSV entered the 500m zone at an excessive speed. The excessive entry speed and direction of approach was observed by the other watch officer on the vessel and also by the crew of the installation who alerted the vessel accordingly.

Thorough investigation revealed the following:

  • Senior Officer confirmed the vessel was moving at a speed in excess of normal approach speed;
  • The 500m pre-entry checks were conducted further away from the installation than normal due to the vessel maintaining what was considered to be a safe distance while dodging infield traffic;
  • The officer on watch had become overly fixated with course over ground and therefore failed to notice he had not yet reduced speed;
  • The vessel pre-entry checklist and that of the installation had differing requirements with regard to when radars should be switched off.

Whilst within the 500m zone, Rule 6 of the Collision Avoidance Regulations (COLREGs) apply:

“Every vessel shall at all times proceed at a safe speed so that she can take proper and effective action to avoid collision and be stopped within a distance appropriate to the prevailing circumstances and conditions”.

Further information on the near-miss is available here.

Latest Safety Flashes:

Hydraulic oil leak detected below moonpool

A hydraulic oil leak was identified below the moonpool after the worktable doors were opened.

Read more
Dropped scaffold board (kickplate) – SIF near miss

A scaffolding kickboard was accidentally dropped falling from a height of 6.5 metres to the main deck.

Read more
H₂S detected on deck

During vessel transit back to port, Hydrogen Sulphide (H₂S) was detected in the open space on the main deck.

Read more
Restoration and verification after maintenance

A missing flooring panel was identified beneath a 415V bow thruster electrical motor cabinet.

Read more
Vessel contact during materiel transfer in adverse weather

One vessel lost heading and position control because of the strong winds and swell, pushing it toward another.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.