LTI – Finger crushed whilst operating safety gate

  • Safety Flash
  • Published on 18 December 2023
  • Generated on 22 February 2026
  • IMCA SF 29/23
  • 1 minute read

 A crew member got his finger trapped in a hinged fall protection bar on a crane pedestal platform, causing serious injury.

What happened?

The crew member was climbing the main crane vertical ladder; when he reached the top of the ladder, he used his right hand to raise the hinged fall protection bar to gain access to the crane pedestal platform.

He kept his right hand on the bar until it was at 180 degrees, trapping his finger between the bar and the handrail.

A crew member got his finger trapped in a hinged fall protection bar on a crane pedestal platform, causing a serious injury.

What went wrong?

Our Member notes that this accident is still under investigation; however, it is recognised that there is potential for a similar event to occur elsewhere where the use of the same or similar type of hinged fall protection bar has been fitted.

Actions

The following action is being taken: An immediate review of all work areas and identify if the same or similar type arrangement is fitted anywhere else.

Our Member notes different or alternate safety gates for consideration:

Crew member got finger trapped in hinged fall protection bar of a crane pedestal platform, causing serious injury

different types of safety gates

 

Latest Safety Flashes:

Fall from height during mooring due to rope tension reaction

Rope became entangled with the propellor during mooring operations of a tanker causing the operator to lose balance and fall onto the lower platform.

Read more
Missing protection – progressive wear on hydraulic hoses causes damage

During an inspection, several hydraulic hoses and fuel hoses were found in direct contact with surrounding surfaces and sharp edges.

Read more
Small engine room fire – flammable object ignited

While ramping up the starboard main engine, a small flammable foreign object ignited.

Read more
Positive: damage to Fast Rescue Craft davit wire rope caught before failure

During routine checks, it was observed that the FRC davit wire rope had a visible fracture at the socket termination area.

Read more
BSEE: Miscommunication and trapped pressure causes injury during valve maintenance

BSEE has published Safety Alert 509 relating to a gas release incident on an offshore platform.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.