Worker struck and injured by tipper truck

  • Safety Flash
  • Published on 2 March 2018
  • Generated on 6 April 2026
  • IMCA SF 05/18
  • 2 minute read

The UK HSE reports the prosecution of a building contractor after a worker was struck and injured by a tipper truck. 

What happened?

The incident occurred at a time of simulataneous operations; there were a number of tipper trucks delivering material to the site and various workers were directing the drivers to different areas.

What went wrong? What were the causes?

The injured worker was walking along a haul road in an attempt to attract the attention of a vehicle in another area of the site when he was struck and run over by a tipper truck. The worker suffered serious injuries including several broken bones in both legs and feet and severe damage to the blood vessels in his legs. His injuries resulted in him having his right leg amputated to the knee over 12 months after the incident.

A HSE investigation found that there were insufficient protected walkways across the site and that there was no control over access to the site. The investigation also found that there was an accepted practice of walking on haul roads and that there was a lack of an up to date traffic management plan.

It was noted that worksites where plant and pedestrians may be operating together should be organised in a way which prevents pedestrians and vehicles coming into contact with each other. This is as true of quaysides and dry dock bottoms as it is of the land-based construction site in this example.

The full press release can be found on the HSE website.

Further IMCA Safety promotional material can also be found on the IMCA Website.

Members may also wish to refer to the following IMCA videos:

Members may also wish to refer to the following guidance:

Latest Safety Flashes:

MAIB: Sinking of tug Biter with loss of two lives

MAIB has published Accident Investigation 17/2024 relating to the girting and capsize of tug Biter with the loss of two lives.

Read more
Dropped object – strop parted over sharp edge

A cylinder was lifted to a height of approximately 6 metres over deck of the vessel, the sharp steel edges of the cylinder cut through the firehose protection and caused the strop to part.

Read more
Person injured when pry bar slipped

A crew member who was applying downward pressure to their pry bar to lift a track, fell towards the deck when the pry bar slipped.

Read more
MSF: High potential near miss during FRC maintenance

The Marine Safety Forum has published Safety Alert 26-01 relating to an incident where there was an unplanned lowering of an FRC to the sea

Read more
BSEE: Crane incident leads to serious facial injuries

BSEE has published Safety Alert 512 relating to a crane incident during well abandonment which led to a worker being struck and suffering serious facial injuries.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.