Fatal Traffic Accident on Board a Large Vessel

  • Safety Flash
  • Published on 25 September 2018
  • Generated on 21 February 2026
  • IMCA SF 22/18
  • 3 minute read

A member reported a fatal incident which occurred on a large Ro-Ro vessel during loading operations.

What happened?

A trailer loaded with two large wooden boxes drove down the ramp to deck number one and parked shortly after clearing the ramp on the port side of the cargo hold. With guidance from the stevedore foreman, the wooden boxes were unloaded by a forklift. When the unloading was finalised, the trailer reversed back up the ramp to deck two and hit the duty officer currently observing the cargo operations. The duty officer received medical assistance from shore very quickly, but unfortunately died in the ambulance on the way to hospital.

Boxes being unloaded by fork lift
Trailer

What went wrong?

Our member made the following findings:

  • No one witnessed the trailer hitting the duty officer.
  • The site of the accident is in a blind spot for the CCTV cameras.
  • The noise level on the cargo decks on this kind of large vessel during loading and discharging is rather high, particularly on cargo deck one. It is not clear that an audible reversing alarm would have changed the outcome in this case.
  • There was no indication that the duty officer was standing outside the yellow safety zone on the ramp when he was hit by the trailer.
  • The duty officer was not wearing his safety helmet as was required. Based on his injuries, the assumption was made that he was hit by the trailer when he was looking up towards deck two.
  • The driver of the trailer did not use any signal man/reversing assistant, nor did he look backward through his trailer window before starting to reverse.
  • Criminal proceedings in the country in which this incident occurred resulted in:
    • the driver of the trailer being prosecuted for negligent driving and sent to prison for 10 months
    • the Stevedore foreman and the head of the stevedore contractor were both fined.

What were the causes?

  • he immediate causes were found to be:
    • the trailer driver failed to ensure that there were no obstructions when starting to reverse
    • driver did not use a signal man/reversing assistant when reversing, even though he was driving a heavy vehicle.
  • A causal factor was inadequate supervision/planning – the requirement to use a signal man/reversing assistant when reversing larger vehicles and trailers on board was not followed.
  • The root cause of the incident was found to be an inadequate management system, which was not strict enough. The sub-contracted stevedore company did not ensure that the owners’ cargo handling instructions were followed.

What actions were taken? What lessons were learned?

  • Better situational awareness is required, particularly in the cargo holds, during cargo operations, and anywhere were vehicles are working.
  • A strengthening of PPE requirements particularly for high visibility clothing. Vessel management teams to ensure that existing requirements for hard hat or safety helmet is always complied with.
  • A better awareness should be developed of control measures for non-routine operations.

Latest Safety Flashes:

Fall from height during mooring due to rope tension reaction

Rope became entangled with the propellor during mooring operations of a tanker causing the operator to lose balance and fall onto the lower platform.

Read more
Missing protection – progressive wear on hydraulic hoses causes damage

During an inspection, several hydraulic hoses and fuel hoses were found in direct contact with surrounding surfaces and sharp edges.

Read more
Small engine room fire – flammable object ignited

While ramping up the starboard main engine, a small flammable foreign object ignited.

Read more
Positive: damage to Fast Rescue Craft davit wire rope caught before failure

During routine checks, it was observed that the FRC davit wire rope had a visible fracture at the socket termination area.

Read more
BSEE: Miscommunication and trapped pressure causes injury during valve maintenance

BSEE has published Safety Alert 509 relating to a gas release incident on an offshore platform.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.